Edited by iamsmiley, 26 August 2010 - 10:53 AM.

iamsmiley's simple auto fruiting chamber system
#1
Posted 26 August 2010 - 10:43 AM
#2
Posted 26 August 2010 - 11:08 AM
#4
Posted 03 September 2010 - 07:40 AM

Nice work on your fruiting chamber. Full automation rocks! I won't be trying your tek, I've got my own setup which I'm happy with, but it looks really good. :bow:
#5
Posted 03 September 2010 - 07:57 AM
I want to do some changes to get closer to your Tec.
I wanna change the perlite layer to a salt/water layer for HR. What do you do with the salt? Do you make a solution salt/water? and pour it in the FC?
I have my airpump on the same schedule as the light. 12 hours on, 12 hours off.
Is your pump running 24/7 if i read it correctly?
#6
Posted 03 September 2010 - 12:01 PM
#7
Posted 05 September 2010 - 09:31 AM
i put salt in the bottom of the fruiting chamber to prevent bacteria from growing in there and i also throw lots of salt in the milk jug(a GOOD size handful) then add water.if the jug gets low after a week just add water after that as the salt stays in the jug.i run my air pump all the time. my lights are 12/12.i tried just putting the salt and water in the bottom of the tub but to much surface area made the mushies to wet so i find a milk jug cheap and the perfect size.Nice 1 IAS. I use some like that too.
I want to do some changes to get closer to your Tec.
I wanna change the perlite layer to a salt/water layer for HR. What do you do with the salt? Do you make a solution salt/water? and pour it in the FC?
I have my airpump on the same schedule as the light. 12 hours on, 12 hours off.
Is your pump running 24/7 if i read it correctly?
#8
Posted 05 September 2010 - 09:32 AM
Mc

#9
Posted 06 September 2010 - 08:26 PM
#10
Posted 16 October 2010 - 09:38 AM
So instead of perlite, you use salt. I got that much. And you have a salt-water solution in the milk jug. BUT- what about the salt in the bottom of the tub? Is it just salt? Or is it salt-water sloshing around? And if it's just salt, how thick of a layer?
Thanks
ISDR
#11
Posted 16 October 2010 - 10:14 AM
don't forget your pencil holes in the corners of your tray,tilt tray to let out excess water and the filter on the top.
Edited by iamsmiley, 16 October 2010 - 11:13 AM.
#12
Posted 08 May 2011 - 01:46 PM
I just wanted to ask a quick easy question. Where are you finding the milk/coke crates you're using in this tek. The few crates I have found have all been to large to fit down into the bottom of my tub! Any suggestions?